Nowadays, industrial production has an important value and significance for the big water mill, which will improve the so-called production efficiency and will make the workers more labor-saving. There is a benchmark for production requirements. So faced with the demand for production capacity, the desire for production capacity is also needed to verify the surface grinding machine in the production of good.
The wide range of application of the big water grinding machine is not only capable of high-precision and high-power grinding, but also grinding with a small roughness of appearance, and it is suitable for processing a variety of hard and brittle materials, so it is widely expected in industrial use.
Large water mill should be carefully before the opening of the machine tool to check all, including the operation of the organization, electrical equipment and magnetic suction cups and other clamps to check. After checking and then smooth, smooth the test run and acknowledge that all intact before use. When loading the workpiece, pay attention to the correctness and tightness of the card, as loosening the workpiece during the grinding process may result in serious consequences such as the workpiece flying out and injuring people or breaking the grinding wheel. At the beginning of the operation, use the hand-adjustment method to make the grinding wheel slower and closer to the workpiece, with a small amount of feed at the beginning, and do not use too much force to avoid bumping the grinding wheel. When using the stopper to control the reciprocating motion of the table, adjust it precisely according to the grinding length of the workpiece and tighten the stopper.
When replacing the grinding wheel, it is necessary to check the appearance first to see if there is any trauma, and then hit it with a wooden hammer or mallet to make sure there is no crack. It is necessary to install the grinding wheel according to the rules and the needs of the device, static balance debugging after the device, test drive, all normal, before use.
In the work to wear protective glasses, dressing grinding wheel should be balanced to avoid banging. Measure the workpiece, adjust or scrub the machine to be carried out after the stop. When using magnetic suction cups, the disc surface and workpiece should be wiped clean, tightened and sucked firmly, and the stopper can be added if necessary to avoid the workpiece from shifting or flying out. Be careful to install the grinding wheel shield or machine block, the station to side over the front of high-speed rotating grinding wheel.